"DVD" and "Delete/*" for the local DVD device,
"AUX" and "Delete/*" for the local AUX device,
"RED" and "Delete/*" for the BOCS RED channel,
"GREEN" and "Delete/*" for the BOCS GREEN channel, or
"BLUE" and "Delete/*" for the BOCS BLUE channel.
2.The power LED will turn on.
3.Press the button to be unlearned.
4.The power LED flashes twice if the key was successfully unlearned, or flashes rapidly if unlearning failed.
5.To unlearn another button, go back to step 3.
6.When you are done with all the buttons to be unlearned for this device, just do nothing. The remote will exit unlearn mode after 10 seconds of inactivity, and the power LED will turn off.
Channel Tuning Delay
Important when the Red, Green, or Blue button is pressed, the remote control attempts to tune the TV channel. Some TVs require longer delays between channel digits transmitted by the remote. Follow this procedure to set longer delays if your TV is having trouble tuning to the correct channel number for Red, Green, or Blue channel.
1.Press and hold TV and CH+ for at least two seconds – until the power light on the remote stays on
2.Press a number button corresponding to the desired channel tuning delay:
1 sets delay to 1/10th of a second
2 sets delay to 1/5th of a second (default factory setting) 3 sets delay to 1/2th of a second
4 sets delay to 3/4 of a second
5 sets delay to 1 second
6 sets delay to 2 seconds
3.If a valid value was entered, the red power light on the remote will flash twice indicating success.
4.If the value entered is not recognized, the red power light on the remote will blink rapidly, in this case repeat the programming procedure.
Channel Tuning Mode (2 or 3 digits or use the +100 key)
Important When you press one of the red, green, or blue BOCS buttons, the remote sends two or more IR digits to the local TV to tune it to the channel for the red, green, or blue device. Some TVs require different digit sequences to tune correctly, especially for channels above 99. Use this function to set the method your TV requires.
1.Press and hold "MENU" & "5" for at least 2 seconds. The power LED will light.
2.Press "1" or "2" to select the tuning mode:
Programming the Remotes | 26 |
