9.Close the sprocket covers. Slide the sprocket units so that the paper is straight and smooth, and then lock them into place.

10.Adjust the top of form position as described in in Chapter 2.

11.Press the FORM FEED button to feed the paper out the back of the printer. Make sure the edge of the first sheet emerges below the paper separator.

12.Close the top cover and press the ON LINE button so you are ready to print.

Using the pull tractor with the rear tractor

If you are using labels or multi-part forms with more than four parts including the original, do not use the rear tractor; use the front tractor instead. See the previous section on using the pull tractor with the front tractor.

You can switch between the front and rear tractors at any time when you are using the pull tractor. Just press the FRONT/REAR button and then use the FORM FEED button to feed the paper the additional distance to the pull tractor. (Labels require special handling. See the section on using labels in Chapter 2.)

Using the Printer Options

6-9