the paper to the desired position. See the section on adjusting the top of form position in Chapter 2.

To reset the tear-off position, take the printer off line and press the TEAR OFF button to enter the tear-off mode and feed the paper to the tear-off position. Then use the MICRO FEED buttons to move the paper to the desired position. See the section on using automatic tear-off in Chapter 2.

To adjust the printing position, take the printer off line and press either MICRO FEED button to advance or reverse the paper to the desired position. See the section on adjusting the printing position in Chapter 2.

WARNING: When using labels, only feed the paper forward with the top MICRO FEED button. Labels must never be fed backward through the printer.

The TOP OF FORM button lets you enter and exit the top of form mode when the printer is off line so you can adjust the top of form position. The top of form position determines where the printing begins on each page.

If your printing is too high or low on the page, you can reset the top of form position by entering the top of form mode and using micro-feed to adjust the position. The printer remembers this new top of form position even after it is turned off, reset, or initialized. Also, the printer remembers separate top of form positions for the front and rear tractors.

If you enter the top of form mode by mistake, you can exit the mode without setting a new position by pressing the ON LINE button. See the section on adjusting the top of form position in Chapter 2.

3-6 Using the Printer