When an ID is set for the projector and the remote control, you can use
the remote control to operate only the projector with a matching ID. This
is very useful when managing multiple projectors.
When operating all of the projectors from the remote control, set the ID
switch on the side of the remote control to Off.
q
•Operation using the remote control is possible only for projectors
that are within the operating range of the remote control.
s "Operating range of remote control" p.19
•When Remote Control Type is set to Simple from Operation in the
configuration menu, you cannot set the remote control ID. p.61
•IDs are ignored when the projector ID is set to Off or the remote
control ID is set to 0.
Setting the Projector ID
Procedure
A
During projection, press the [Menu] button and select
Extended - "Projector ID" from the configuration menu.
s "Using the Configuration Menu" p.54
Using the Remote Control Using the Control panel
B
Select of one of the numbers from 1 to 9 to use as the ID and
then press the [Enter] button.
C
Press the [Menu] button to close the configuration menu.
Checking the Projector ID
Use the following procedure to check the projector ID.
Limitation of the Number of the Target Projectors when Using Multiple Projectors42