Items that can be set vary depending on the image signal or input source currently being projected as shown in the following screen shots. Setting details are

saved for each image signal.

You cannot make settings in the Signal menu when the input source is USB or LAN. (EB-G5950/G5650W)

RGB Signal Component Video Signal
g
Composite video Signal
g
/S-Video
Signal
g
HDMI
*

* EB-G5950/G5900/G5650W/G5600 only

Sub Menu Function
Auto Setup You can select whether or not (On/Off) Auto Setup automatically adjusts the image to the optimum state when the Input Signal changes.
Resolution Auto: The resolution of the input signal is automatically identified.
Wide, Normal: If the images cannot be projected correctly when Auto is set, set this menu. Set to Wide depending on the connected
computer for wide screens, or set to Normal for 4:3 or 5:4 screens.
Manual: You can specify the resolution. This is ideal when connected computer is fixed.
Tracking
g
You can adjust computer images when vertical stripes appear in the images.
Sync.
g
You can adjust computer images when flickering, fuzziness, or interference appear in the images.
Position You can adjust the display Position up, down, left, and right when a part of the image is missing so that the whole image is projected.
Progressive
*1*2
Off: IP conversion is carried out for each field in the screen. This is ideal for viewing images with a large amount of movement.
Video: This is ideal for viewing general video images.
Film/Auto: By automatically converting movie films, CG, animated images, an d so on recorded in 24/30 frames to the optimum progressive
signal via 2-3 pull-down, it is possible to recreate the natural feel of the original image.
Noise Reduction
*2
Smoothes out rough images. There are two modes. Select your favorite setting. It is recommended that this is set to Off when viewing image
sources in which noise is very low, such as for DVDs.
Signal Menu
57