Status Cause Remedy or Status
Low Air Flow (This is not an abnormality. However, projection stops automatically if the airflow falls any further.)
The message "The air filter is clogged. Clean or replace the air filter. " is displayed. Check the following two points.
•Check that the air filter and air exhaust vent are clear, and that the projector is not positioned against a wall.
•If the air filter is clogged, clean or replace it. s p.101, p.107
If the Low Air Flow status continues after cleaning the air filter, replace the air filter with a new one. s p.107
If the error continues after checking the points above, stop using the projector, disconnect the power cable from the electrical
outlet, and contact your local dealer or the nearest address provided in the Support and Service Guide. s Epson Projector
Contact List
Air Filter Notice The following message may also be displayed: "Time to clean the air filter. Clean or replace the air filter." Clean the air filter.
s p.101
If the air filter is stained yellow with tobacco smoke and cannot be cleaned, replace it with a new one.
The indicators or messages regarding "Air Filter Notice" are displayed only when Air Filter Notice is set to On, on the
configuration menu's Extended menu. s p.61
q
•If the projector is not operating properly, even though the indicators are all showing normal, refer to “When the Indicators Provide No Help”.
s p.91
•If the error is not indicated in this table, stop using the projector, disconnect the power cable from the electrical outlet, and con tact your local dealer or the
nearest address provided in the Support and Service Guide. s Epson Projector Contact List
Problem Solving
90