Sub Menu Function
Operation Direct Power On: You can set whether or not (On/Off) to enable Direct Power On.
Be careful when this item is set to On because this unit turns on at the time of power recovery with this unit plugged-in to an outlet.
Sleep Mode: When set to On, this automatically stops projection when no image signal is being input and no operations are carried
out.
Sleep Mode Timer: When Sleep Mode is set to On, you can set the time before the projector automatically turns off within a range of 1 to
30 minutes.
High Altitude Mode: Set to On when using the projector above an altitude of 1500 m.
BNC Sync Termination: Set the termination for the signal from the BNC input port. This should usually be set to Off. Set to On when
analog (75Ω) termination such as for switchers is necessary.
Remote Control Type: You can select Normal or Simple depending on the type of remote control.
Set this item to Normal to use the remote control provided with the projector. When Simple is selected, you can use the remote control
provided with other Epson projectors to operate this projector. This is useful if you want to use a remote control that you are already
familiar with to operate the projector. (When using the remote control that is supplied with an EB-G50xx to EB-G53xx-series or EB-
Z80xx-series projector, select Normal.)
However, you cannot use the remote control provided with this projector if this is set to Simple. Make sure that the setting is correct
because, if the projector is mounted on the ceiling or somewhere hard to reach, changing it back to Normal may be difficult. Additionally,
you cannot use the functions that are not equipped with this projector or the remote control which you use.
Inv Direction Button: Set this to On when suspending the projector from the ceiling. s p.131
Standby Mode You can use the functions that monitor and control the status of the projector over the network even when the projector is in standby mode
if this is set to Communication On.
Air Filter Notice You can set whether or not (On/Off) to enable Air Filter Notice. When this is set to On and a clog in the air filter is detected, the message
is displayed on the screen.
Projector ID Set the ID within a range of 1 to 9. Off indicates that no ID is set. s p.42
Multi-screen You can adjust the hue and brightness of each projected image when two or more projectors are lined up and projecting. s p.45
Adjustment Level: You can adjust from black to white in five stages called Level 1 to 5, and in each of these 5 levels you can adjust
Brightness Correct. and Color Correct.
Brightness Correct.: Corrects the difference in the brightness of each projector.
Color Correct. (G/R) / Color Correct. (B/Y): You can correct the difference in the color of each projector.
Language You can set the Language for message displays.
Extended Menu
62