Epson EMP-760, EMP-765 Search] button is pressed, The input source can also be searched for and, projected automatically each time the [Source

User’s Guide

Turning the Projector On 37

4	If more than one external device is connected to the
	projector, use the remote control or projector control
	panel buttons to select the image source to be
	projected while referring to the following table.
	The input source can also be searched for and
	projected automatically each time the [Source
	Search] button is pressed.
	Remote control	Projector

Source	Remote control	Display at top-right of screen
	button selected
Computer/		Computer (Auto)*1
	Computer	Computer*1
Component Video
		Component Video*1
S-Video	S-Video	S-Video
Video	Video	Video
EasyMP*2	EasyMP	EasyMP

*1 Displays the selected source as the "Computer Input" - "Signal" in the configuration menu.

*2 Only changes when using the EMP-765.

sEasyMP Operation Guide and the EasyMP Network Setup Guide for details on using EasyMP.

TIP

•If only one signal source has been connected, the signals from that source will be projected without the need to press any of the buttons on the remote control or the projector's control panel.

•If using an EMP-765, EasyMP is detected as a source by pressing the [Source Search] button only when the CardPlayer is running with an inserted memory card or connected USB equipment, or when a LAN card is inserted. When EasyMP is not displayed by the [Source Search] button, press the [EasyMP] button on the remote control to switch the projected image to EasyMP.

•If the "No Signal." message does not disappear, check the connections again.

•If a laptop computer or a computer with an LCD screen has been connected to the projector, the images may not be projected straight away. After starting projection, check that the computer has been set up to output signals externally.

The following table shows examples of how to toggle output settings. For details, refer to the section of the documentation provided with your computer under a heading such as "External output", "Connecting an external monitor" or similar.

NEC	Panasonic	Toshiba	IBM	Sony	Fujitsu	Macintosh
[Fn]+[F3]	[Fn]+[F3]	[Fn]+[F5]	[Fn]+[F7]	[Fn]+[F7]	[Fn]+[F10]	Set mirror setting or
						display detection.

•If the same still picture is projected for a long period of time, the projected image may become burned into the screen. You should avoid leaving the same image displayed for long periods.