Epson EMP-760, EMP-765 selected, turned on, projector, Problems Solving, with a built-inLCD screen, a laptop computer or computer, Only when projecting images from

				User’s Guide
Problems Solving					82
		The message "No Signal." is displayed
			Check	Remedy
	Are the cables connected correctly?			Check that all of the cables required for projection are securely connected. sp.20– p.26
	Has the correct video input port been			Press the [Computer], [S-Video], [Video] or [EasyMP](EMP-765 only) button on the remote control
	selected?			or the [Source Search] button on the remote control or the projector's control panel to change the
				image. sp.37
	Is the power for the computer or video source			Turn the power on for the devices. sp.36
	turned on?
	Are the image signals being output to the			If the image signals are only being output to the computer's LCD monitor or to the accessory
	projector?			monitor, you need to change the output to an external destination as well as the computer's own
				monitor. For some computer models, when the image signals are output externally, they no longer
			Only when projecting images from
				appear on the LCD monitor or accessory monitor.
			a laptop computer or computer	s Computer documentation, under a title such as "External output" or "Connecting an external
			with a built-in LCD screen	monitor"
				If the connection is made while the power is already turned on, the function [Fn] key that switches
				the computer's video signal to external output may not work. Turn the power for the projector and
				the computer off and then back on again. sp.36, p.38
		Images are fuzzy or out of focus
			Check	Remedy
	Has the focus been adjusted correctly?			Turn the focus ring on the projector to adjust the focus. sp.40
	Is the lens cover still attached?			Remove the lens cover. sp.35
	Is the projector at the correct distance?			The recommended projection distance range is 100–1210 cm (3.2–39.7 ft.). Set the projector up so
				that it is within this range. sp.16
	Is the keystone adjustment value too large?			Decrease the projection angle to reduce the amount of keystone correction. sp.43
	Has condensation formed on the lens?			If the projector is suddenly taken from a cold environment to a warm environment or if sudden
				ambient temperature changes occur, condensation may form on the surface of the lens, and this may
				cause the images to appear fuzzy. Set the projector up in the room approximately one hour before it
				is to be used. If condensation forms on the lens, turn the power off and wait for the condensation to
				disappear.