User’s Guide

Adjusting the Screen Image

 

42

 

 

 

PROCEDURE

While pulling the foot adjust lever at the front of the projector, lift up the front of the projector to extend the front adjustable foot.

Extend the front adjustable foot until the desired angle is obtained, and then release the foot adjust lever.

To retract the front adjustable foot, gently push down on the projector while pulling the foot adjust lever.

If you tilt the projector up, keystone distortion will occur in the projected screen. However, the projector is equipped with an automatic keystone correction function that can automatically correct this keystone distortion on the screen. Automatic keystone correction is carried out approximately one second after the projector is tilted vertically while the power is on.

Foot adjust lever (Front)

TIP

When the projector is tilting horizontally, turn the left rear adjustable foot until the projection is level. When the projector is tilted horizontally, the correction may not be carried out correctly. sp.42

Rear adjustable foot

TIP

•Automatic keystone correction is not carried out when the "Projection" command in the "Extended" menu is set to "Front". •If you would like to make further fine adjustments after automatic keystone correction has been carried out, press the [] and [] buttons on the projector's control panel. sp.43

•When keystone correction is carried out, the projected image will become smaller.

•If the text part of the image is blurred after keystone correction is carried out, decrease the sharpness setting. sp.56, p.58

•If automatic keystone correction is not required, set "Auto Keystone" in the "Setting" menu to "OFF". sp.62

Extend Retract