Epson EMP-760, EMP-765 Normal, Power indicator lights green or orange/flashes green or orange

User’s Guide

Problems Solving										77
							: lit	: flashing	: off
		Status	Cause			Remedy or Status
			Lamp replacement notification	Replace the lamp with a new one. sp.101
		Orange		If you continue to use the lamp after it has passed the replacement period, the possibility that the
				lamp may break will increase. Replace the lamp with a new one as soon as possible. The Power
				indicator status will vary depending on the projector status at the time.
	Power indicator lights green or orange/flashes green or orange						: lit	: flashing	: off
					Normal
		Status	Cause			Remedy or Status
		Orange	Standby condition	Projection starts again when the [Power] button is pressed.
				You can disconnect the power plug from the electrical outlet when the status light is in this
				condition.
		Green	Warm-up in progress	Warm-up time is approximately 40 seconds. After warm-up is complete, the indicator stops
				flashing.

Green Projection in progress

Orenge	Cool-down in progress	Please wait.
		•The [Power] button will not operate if it is pressed while cool-down is in progress. When the
		cool-down period is finished and the confirmation buzzer has sounded and the indicator changes
		to light orange, repeat the operation.

TIP

•If the projector is not operating properly even though the indicators are all showing normal, refer to "When the Indicators Provide No Help" on the following page.

•If an indicator is showing a status which does not appear in the previous tables, contact your dealer or the nearest address provided in the "International Warranty Conditions" section of the Safety Instructions/World-Wide Warranty Terms booklet.