Epson EPL-8000 [E]SERVICE REQ. CXXXX, [E]SERVICE REQ. E00XX, [E]SET FULL PRINT, [E]SAVE MEMORY OVERLOW, [W] SET MANUAL, [S] STANDBY MODE

Status and Error Messages

[E]SAVE MEMORY OVERLOW

This message may appear when you are trying to save a macro with the SAVE MACRO option. The printer does not have enough memory to save the macro. To correct this error, delete unused macros using the DELETE MACRO option.

[E]SERVICE REQ. CXXXX

A controller error has been detected. Write down the error number listed on the display and turn off the printer. Wait at least five seconds and then turn it back on. If the error message still appears, turn off the printer, unplug the power cord, and contact a qualified service person.

[E]SERVICE REQ. E00XX

A print engine error has been detected. Write down the error number listed on the display and turn off the printer. Wait at least five seconds and then turn it back on. If the error message still appears, turn off the printer, unplug the power cord, and contact a qualified service person.

[E]SET FULL PRINT

This message may appear when you are trying to print graphics or a mix of text and graphics. Press CONTINUE and then change the SelecType FULL PRINT setting as described in Chapter 3.

[W] SET MANUAL

There is no paper in the manual feed tray and you have selected manual feed. Load a sheet of paper in the manual feed tray. To cancel manual feed, press the MANUAL button to feed paper from the paper cassette. This message alternates with CANCEL MANUAL FEED.

[S] STANDBY MODE

If all of the channels receive no data for about thirty minutes and the STANDBY mode is enabled in SelecType, the printer enters standby mode. Press any panel button or send data to warm up the printer,

Troubleshooting 6-7