4Attach the ceiling plate to the ceiling at the pre-drilled location. Use two of the included wood screws.

5Drill the remaining four holes with the ceiling plate in place. Finish securing it with the remaining wood screws.

Mount the Projector

Before mounting the projector, you may find it easier to perform the following tasks first:

•Plug in the projector and turn it on, then invert the image so it’s oriented correctly when the projector is hung from the ceiling. See “Adjusting the Projector Settings” on page 56.

•Attach the wire management track to your ceiling before hanging the projector (see “Connecting and Routing the Cables” on page 43). It’s easier to attach the track near the projector’s ceiling mount before the projector has been mounted.

1Unpack the projector from the projector box, located inside box #1. Keep the lens cap on the projector for now. Make sure you have the parts shown below.

Note

Your Ensemble HD system may come with a different projector model than the one shown here. The projector box may also include additional parts.

Batteries

Projector

Remote control

2Save the projector User’s Manual and PrivateLine card for the customer. The PrivateLine card can be used to obtain quick technical support.

3Unpack the projector enclosure/rear speaker assembly from box #2. Note that screws are included for securing the projector to the enclosure. Be sure to unpack all the hardware shown below.

Cleats (optional) for

Screws and washers

wrapping excess cable;

for mounting projector

and cleat screws

to enclosure

Projector enclosure and rear speaker assembly

38