Adjusting the Projector Settings

Use the projector’s remote control to adjust the following settings.

Note

If you need to restore the projector’s factory settings, open the Reset menu and select Reset All.

1Press the HDMI button on the remote control to select HDMI as the source.2Press the Menu button on the remote control. You see the main menu screen:

Projector remote control

3Open the Settings menu (press the d button to highlight Settings, then press Select).

4To invert the image, press the d button to highlight Projection, then press the Select button. Select Front/Ceiling, then press . The image is inverted.

Press the Esc button to return to the Settings menu.

5If the projector is installed above 4900 feet (1500 meters), turn on High Altitude Mode so the fan can properly cool the projector.

Press the Esc button to return to the Settings menu.

6Highlight Display and press . For the Startup Screen setting, select Off. Press the Esc button twice to return to the main menu.

7Open the Signal menu and set Output Scaling to 100%.

Note

To adjust this setting, the AV controller must be turned on so that the projector is receiving a signal.

8Press the Esc button as needed to exit the menu system.

56