6Press the u or d button to select the type of device you’ve connected, then press the SEL (Select) button. (The names in this step correspond to the categories of devices found in the code tables.)

7Point the remote control at the component, then enter the first three-digit code number from the code table. (You do not have to press SEL or ENT to enter the code.) After you enter a three-digit code, look at the component to see if it has turned off.

Continue to enter code numbers until the component turns off.

8When the component turns off, save the code number you entered by selecting the SAVE option on the LCD screen.

9Press the MAIN button twice to exit the SETUP menu.

10Test the Ensemble HD remote control to make sure it has all the functions you need. When you open the new component’s menu, you should see all the functions needed to operate it. If any commands are missing, you can copy them from the component’s original remote control. For instructions, see the section on using advanced remote control features in the User’s Guide.

Note

Refer to the manual that came with your component for instructions on using the commands to operate it.

Connecting Another Subwoofer

To increase the bass presence in extra-large rooms, you can connect an additional powered subwoofer to the system. Set the added subwoofer’s bypass switch to bypass its built-in crossover (if it doesn’t have a bypass switch, set its crossover frequency to the maximum). Use an RCA-style audio cable and connect it to the SUB OUT port on the back of the Ensemble HD subwoofer:

BASS CONTOUR CONTROL

FREQLEVEL

61 82

4798

99

PWR ON MODE

SUB OUT

Connect additional powered subwoofer here

MASTER

POWER

68