The Cut Sheet Feeder

Setting the sheet feeder mode

To allow your printer to use the cut sheet feeder you will need to set DIP switch 1-7 to on. If you need more information on how to

do this, see the section on DIP switch setting in Chapter 3. To set the printer into the cut sheet feeder mode, you should do the following:

•Turn the printer off

•Set DIP switch 1-7 to the on position using a pointed object, such as the tip of a pencil.

•Turn the printer back on.

All changes of DIP switch settings should be made with the printer power turned off. The printer checks and recognizes new settings only at the time the power is turned on.

Recommended paper

Paper:

For best results, use typewriter quality paper. If you

 

plan to use paper with a glossy or textured surface, you

 

should test it before regular use. Do not use multiple-

 

part forms or labels.

Envelopes: You can print on air mail, plain, or bond envelopes. Before printing on envelopes, you need to set the paper thickness lever according to the thickness of the envelope. For specific information on paper thickness settings, see the section on printing with special paper in Chapter 2.

Printing past the edge of envelopes, multi-part forms or thicker than normal paper can damage the print head.

When you print on anything thicker than normal paper, be absolutely sure that none of the printing is closer than 1/4 of an inch to the edges.

7-7