Adjusting the Loading Position

To perform micro adjustment of the loading position, first load your paper, and then press the ON LINE button to set the printer on line. The MULTI-PARTindicator light starts to flash. While this light is flashing, you can use the FORM FEED and LINE FEED buttons for micro adjustments.

Now press the FORM FEED button to feed the paper forward or the LINE FEED button to feed the paper backward.

Each time you press the button, the paper moves 1/180 of an inch. If you hold the button down, the paper moves continuously in 1/180 of an inch increments.

When the paper reaches the factory set loading position, the printer beeps and micro-adjustment feeding pauses for a moment before continuing. You can use this factory setting as a reference point when adjusting the printer’s loading position.

1 Micro adjustment can be used to adjust the loading position

A. immediately after loading paper only. Using micro adjustment on continuous paper establishes a new loading position that remains valid even after the printer is turned off, reset, or initialized. When using micro adjustment on single sheet paper, the new loading position does not remain valid after the printer is turned off or reset. When the paper reaches either the minimum or maximum top margin, the printer beeps and the paper stops moving.

3-13