The Cut Sheet Feeder

1.Make sure that the continuous paper is already loaded and in a standby position as explained in Chapter 2.

2.Install the cut sheet feeder as described in this section, making sure that DIP switch 1-7 is set to on, and that the paper release lever is pushed all the way back.

3.To switch from cut sheet feeder operation to continuous paper,

pull the paper release lever all the way forward. You will not need to change the DIP switch setting.

4Raise the paper path guide until it clicks open, as shown below. This guide directs the flow of continuous paper out the front of the printer.

5.Continuous paper can now be loaded. With the paper release lever forward, the control panel functions normally, allowing you to use the micro-adjustment feature to finely adjust the loading position of your paper.

6.To switch back to cut sheet feeder operation, push the LOAD/EJECT button until the continuous paper feeds backward out of the paper path and into a standby position. Then, push the paper release lever back to put the printer into the sheet feeder mode.

7.Close the paper path guide.

7-15