Maintaining and Transporting the Printer 137
Follow these steps to use maintenance mode:
1.Make sure the printer is turned off.
2.Press and hold the 
Pause button, then press the P Power button and hold it until the printer turns on and displays MAINTENANCE.
3.Use the d and u buttons to select the settings described below. If you need to back up to the previous menu level, press the l button.
•To print a hex dump of data in the printer’s buffer, press the Menu button to display PRINT. Then press the 
button to print the 
Pause button to print the last page.
•To change the language on the LCD display, press the d button to highlight LANGUAGE, then press Menu. Press the d button until you see the language you want, then press 
to select it. The printer exits maintenance mode and returns to normal operation.
•To enable remaining paper counter, press the d button to highlight REMAINING PPR SETUP, then press Menu. Press the d button to select ROLL, then press 
.
•To change the units of measurement, press the d button to highlight UNIT, then press Menu. Press the d button to switch from METER to FEET/INCH, then press 
to select it. Press the l button when done.
•To change the default cutting pressure, press the d button to highlight CUT PRESSURE, then press Menu to display 100%. Press the d button to decrease the pressure, or the u button to increase it (in 1% increments). Press 
to select the setting you want.
•To run a super strong cleaning cycle, press the d button to highlight SS CLEANING, then press Menu to display EXEC. Press 
to start the cleaning cycle.
•To enable roll paper feeding at 
to save it.