2.4.5Speed Dome Installation

Speed dome or telemetry receiver pan/tilt/zoom control is available through web browser or the optional PowerCon software if the DVR is connected to a network. Local telemetry control is provided by USB - mouse control or by the optional EKB-500 keyboard.

Supported protocols: EverFocus, Pelco-D, Pelco-P, Samsung, Transparent

Required DVR settings: RS-485 receiver address in CAMERA menu

( chapter 5.10.4.)

RS-485 parameters and protocol in the I/O CONTROL menu

( chapter 5.10.4.)

ATTENTION: Some Pelco-D / -P protocol domes and receivers require an address offset of -1, i.e. the address assigned to the dome / receiver in the DVR camera menu must be 1 below the address set in the dome / receiver itself!

2.5 RS-232 Connection

1 2 3 4 5

6 7 8 9

Pin

Function

2

TXD

3

RXD

5

Ground

2.6 USB-Mouse installation

Connect the USB mouse to one of the 2 USB ports. (This can be done while DVR is powered on)

NOTE: Recommended mouse types are Logitech® and Microsoft® wired USB wheel-mouse. Wireless USB mouse is not supported.

18

Page 25
Image 25
EverFocus 264x4, 264x2 instruction manual Speed Dome Installation, 3 4 Pin Function