Controls and Installation, cont’d
Installation
Easy setup procedure
Except where noted, the installation procedures for the RGB 130xi, 134xi, and 150xi are the same. See “Cabling” in this chapter for more information.
1
If desired, mount the interface to a desk or other suitable surface using Extron’s optional mounting kit. See “Mounting the interface” in the next section.
2
Turn off power to the computer or workstation and its monitor. Turn off power to the projector or display device. Disconnect the power cord from the interface.
3
4
Connect the computer to the Analog/ECL* input connector on the front of the interface. If an MBC interface output cable is being used with the RGB 134xi, connect the MBC cable to the Analog/ECL connector and connect the MBC power cable to the MBC power jack. Refer to the diagram in the “Cabling” section of this chapter.
For the RGB 150xi, if a local computer monitor is being used, connect the monitor to the Buffered Local Monitor Output connector.
5
6
7
8
For audio connections, please refer to the following “Cabling” and “Connecting audio output” sections.
Connect the projector or other output display device to the interface’s BNC output connectors, as described in the “Cabling” section.
Set the interface’s DIP switches. Refer to the section “Setting the DIP switches” at the end of this chapter.
Power on the computer, monitor, projector/display device, and the interface. The image should now display on screen. If it does not, double check steps 2 through 7 and make adjustments as needed. To adjust horizontal and vertical sync polarity and to set vertical sync pulse width, please refer to the “Setting internal jumpers” section at the end of this chapter.
* RGB 150xi is analog only
