Extron electronic 134xi, 130xi, 150xi user manual Balanced audio

Controls and Installation, cont’d

3.Slide the audio cable connector into the audio output connector on the interface.

Balanced audio

To attach the interface to a balanced audio system, do the following:

1.Attach the audio cable to a balanced speaker input connector (tip, ring, and sleeve).

Tip (+) Sleeve

Ring (-)

Tip (+)

Sleeve

2.Attach the audio cable to the audio cable connector (Extron part number 10-319-10). Fasten the captive screws inside the audio cable connector as shown in figure 2-14.

Balanced Output

Tip

Ring

Sleeve (s)

Tip

Ring

Connect the sleeve(s) to ground (GND). Connecting the sleeve(s) to a negative (-) terminal will damage audio output circuits.

3.Slide the audio cable connector into the audio output connector on the interface.

2-13 RGB 130xi , 134xi , 150xi Controls and Installation