Extron electronic 150xi, 130xi, 134xi user manual Attaching the through desk brackets

Controls and Installation, cont’d

To mount the interface through a desk or table, do the following:

1.Attach the mounting brackets to the interface using four machine screws and washers (supplied with the mounting kit), as indicated in figure 2-9.

Figure 2-9 — Attaching the through desk brackets

2.Using the to-scale template at the back of this manual to guide you, mark the four screw holes on the underside of the surface to which you are mounting the interface. Use the through desk mounting template to cut the hole.

3.Drill four pilot holes, each 3/32” in diameter by 1/4” deep, where marked.

4.Using the four wood screws provided, attach the brackets to the mounting surface, as shown in figure 2-10.

Figure 2-10 — Mounting the interface in a table

2-9 RGB 130xi , 134xi , 150xi Controls and Installation