Extron electronic GSS 100 manual Front Panel Operations, Power-onIndications, Default Cycle

Front Panel Operations

Plug in all system components and turn on the input device (such as a desktop or laptop computers) and the output monitor. Use the LAN port to upload one or more still images to the GSS. Select either the pass-through input or one of the stored still images to output (see “Selecting an Image to Display”). The image should appear on the monitor connected to the output.

Power-on Indications

Power is applied when the power cord is connected between the GSS and an AC source. When AC power is applied, the GSS performs a self-test that shows the model name and the firmware version in the LCD display. After approximately 15 seconds, the LCD diplays its default cycle, alternating among four displays that show the model name, the currently displayed image (the pass-through input or the file name of one of the previously loaded images), the output resolution (of a stored image only; the pass-through input is output exactly as it is input), and the IP address of the unit (see figure 7).

The current settings are saved in nonvolatile memory. When power is applied, the latest configuration is retrieved.

NOTE: On figure 7 and all other flowcharts in this chapter, dashed lines indicate screen

	changes that are the result of a timeout function.
Power
on
Extron		Default Cycle
GSS 100				Viewing
3 sec.
			PassThru
Version	3 sec.	Extron 3 sec.		or	3 sec.
		GSS 100		Viewing
n.nn
				Image
		1024 x		3 sec.	I192.168 3 sec.
		768	@72		P255.255

or

RGB

PASSTHRU

Figure 7. LCD Power-on Displays and Default Display Cycle

NOTE: If the displayed file name is too large (more than eight characters, including the file extension) for the LCD, the LCD shifts the file name:

Viewing Largefil

Viewing

lename.jp

Viewing

ename.jpg

GSS 100 Graphic Still Store • Operation 8