Output configuration
NOTE: The output configuration settings apply only to the the output of still images
stored in the GSS; the RGB
RteX%*X^]
The GSS 100 initiates the Rte message when a front panel change in the output resolution takes place.
SynX&]
The GSS 100 initiates the Syn message when a front panel change in the output sync format takes place.
PolX*]
The GSS 100 initiates the Pol message when a front panel change in the output sync polarity takes place.
DlyX#]
The GSS 100 initiates the Dly message when a front panel change in the RGB delay interval takes place.
Auto-switch and slide show control
PasX@]
The GSS 100 initiates the Pas message when a front panel change in the
AutX$]
The GSS 100 initiates the Aut message when a front panel change in the
SliX#]
The GSS 100 initiates the Sli message when a front panel change in the slide display duration takes place.
Front panel locks
ExeX@]
The GSS 100 initiates the Exe message when a front panel change in the front panel lock on or off status takes place.
Host-to-GSS Instructions
SIS commands consist of one or more characters per field. No special characters are required to begin or end a command character sequence. When a command is valid, the unit executes the command and sends a response to the host device. All responses from the unit to the host end with a carriage return and a line feed (CR/LF = ]), which signals the end of the response character string. A string is one or more characters.
GSS 100 Graphic Still Store • Programming Guide 20