Command and Response Table for SIS Commands
Command | ASCII Command | Response | Additional description |
| (Host to Unit) | (Unit to Host) |
|
Image recall |
|
|
|
Recall an image to buffer | EX!RF} | Cim•X!] | Select image X! to display. |
NOTE: It takes several seconds between the issuance of the recall command (EX!RF}) and the receipt of the Cim response.
Show the image that is | ERF} | X!] | The buffer is loaded with image X!. |
currently displayed |
|
|
|
Take | % | Tke] | Swap the displayed and buffered images using the |
|
|
| selected effect (cut or dissolve). |
Switch effect
Set the effect to cut | 9*0# |
Set the effect to dissolve | 9*1# |
Read the effect | 9# |
Set the dissolve duration | 10*X## |
Read the dissolve duration | 10# |
Eff0] | Set the effect for switching images to cut (immediate). |
Eff1] | Set the effect for switching images to dissolve. |
X@] |
|
DurX#] | Set the duration of the dissolve effect to X#. |
X#] | The dissolve duration is X#. |
Source selection
Display | 1! | Chn1] | Display the |
Display last image | 0! | Chn0] | Display the previously selected stored image. |
View | ! | X@] |
Slide show interval
Set slide show interval | 2*X## | SliX#] | Set the display time for each image to X# seconds. |
Read slide show interval | 2# | X#] | The display time for each image is X# seconds. |
Pass-through configuration
Enable | 1*1# | Pas1] | Include the |
Disable | 1*0# | Pas0] | Do not include the |
Read the | 1# | X@] | Show the status of the |
Auto-switch and slide show mode
Set | 4*X$# | AutX$] | Set |
show mode |
|
| 0 = Off — |
|
|
| and slide show are disabled. |
|
|
| 1 = Off/show — |
|
|
| is disabled. Slide show is running. |
|
|
| 2 = On/still — On loss of sync on the |
|
|
| input, |
|
|
| displayed image until |
|
|
| sync is restored. |
|
|
| 3 = On/show — On loss of sync on the |
|
|
| input, |
|
|
| show until sync on the |
|
|
| input is restored. |
Show | 4# | X$] |
|
show mode |
|
|
|
NOTE: X! = Image file name | Image name with file extension (*.bmp or *.jpg) | ||
X@ = Cut / dissolve status: | 0 = cut | 1 = dissolve | |
0 = | 1 = no | ||
X# = Time (duration) | 00 – 50 (0.0 to 5.0 seconds) for dissolve duration | ||
|
| 000 – 300 seconds for slide show interval | |
X$ = | 0 = off | 2 = on / still | |
|
| 1 = off / show | 3 = on / show |
GSS 100 Graphic Still Store • Programming Guide 22