Extron electronic GSS 100 manual Advanced menu, Auto Switch and slide show submenu

Advanced menu

Figure 14 is a flowchart that shows an overview of the Advanced menu and the available settings.

Power	Default
on	Cycle
	Menu
10
sec.	Switch
	Effect
10	Menu
sec.	Output
	Config
10	Menu
sec.	Slide
	Show
10	Menu
sec.	Advanced	Next
	Menu
10	Menu
sec.	Exit
Menu
	Menu

	Menu		10 sec.		Menu	3 sec.				10 sec.
						{scroll}
	Auto Sw			Next	Name				Name	Next
	Off				GSS-100-			nn-nn-nn
					Name (Display Only)
				(Changeable under RS-232/Ethernet control;
	Auto Switch			scrolls to the left if greater than 8 characters.)
•	Off	•	Off/show
•	On/still	•	On/show
					Menu				Menu
					nn:nn:nn Next			Int Temp		Next
					nn:nn:nn			113F 45C
					MAC Address			Temperature
					(Display Only)			(Display Only)
	Menu						Menu
	RS-232		Next				I192.168		Next
	9600						P254.254

	Baud Rate			TAKE	Press Take to
•	2400	•	19200		enable changing
•	4800	•	38400		the value.
•	9600	•	115200		Rotate Adjust/
					Select to change

the value.

TAKE	Press Take to enable
	changing the value
	and select an octet.

Rotate Adjust/Select to change the value in the selected (blinking) octet.

Figure 14. Advanced Submenu Flowchart

Auto Switch (and slide show) submenu

The GSS can be set to an auto-switch mode that monitors the sync signal on the RGB pass- through input and automatically switches to the last-displayed stored image or slide show for output when sync is lost. This submenu also allows you to turn the auto-switching and slide show on and off.

Rotate the Adjust/Select mode while in the Auto-Switch submenu to select:

zzOff (auto-switch mode off and slide show off) — Deactivates the automatic sync detection and the slide show.

zzOff/show (auto-switch off and slide show on) — Leaves the automatic sync detection off and manually initiates the slide show. If the pass-through input was being displayed when this selection is made, the GSS displays the first image alphabetically by file name.

zzOn/still (auto-switch on and slide show off) — Activates the automatic sync detection and auto-switches to the still image. If sync is lost, the GSS switches to the last displayed image that was output and outputs that image until sync is restored or you select another image to display.

zzOn/show (auto-Switch on and slide show on) — Activates the automatic sync detection and auto-switches to the slide show. If sync is lost, the GSS switches to the last-displayed image and begins to cycle through the available images.

The default setting is Off.

GSS 100 Graphic Still Store • Operation 14