Command and Response Table for
Command | ASCII Command | Response | Additional description |
| (host to unit) | (unit to host) |
|
IP and port setup commands
Set device name Read device name
Reset device name to factory default
Set time and date Read time and date Set GMT offset
EX4)CN} | Ipn•X4)] |
ECN} | X4)] |
E•CN} | Ipn•X4!] |
EX4@CT} | IptX4@] |
ECT} | X4#] |
EX4$CZ} | IpzX4$] |
In the command, the divider between hours and minutes can be either a colon (:) or a period. In the response, the divider is a colon.
Example:
Set Daylight Saving Time Read Daylight Saving Time Set IP address
Read IP address
Read hardware address Read # of open connections Set subnet mask
Read subnet mask
Set gateway IP address Read gateway IP address Set administrator password Read administrator password
Reset (clear) administrator password
Set user password Read user password Reset (clear) user password Set DHCP on or off
Read DHCP on/off status Set serial port parameters
Example:
Read serial port parameters Configure current port timeout View current port timeout Set global IP timeout
View global IP timeout Set verbose mode Read verbose mode
E8.0CZ} | Ipz+08:00] |
|
EX4%CX} | X4%] |
|
ECX} | X4%] |
|
EX4^CI} | IpiX4^] |
|
ECI} | X4^] |
|
ECH} | X4&] |
|
ECC} | X4*] |
|
EX4^CS} | IpsX4^] |
|
ECS} | X4^] |
|
EX4^CG} | IpgX4^] |
|
ECG} | X4^] |
|
EX4(CA} | Ipa•X4(] |
|
ECA} | X4(] |
|
E•CA} | Ipa•] |
|
EX4(CU} | Ipu•X4(] |
|
ECU} | X4(] |
|
E•CU} | Ipu•] |
|
EX5)DH} | IdhX5)] | X5): 0 = off, 1 = on |
EDH} | X5)] |
|
EX5!*X5@,X5#,X5$,X5%CP} CpnX5!•CcpX5@,X5#,X5$,X5%] | ||
E01*9600,N,8,1CP} | Cpn01•Ccp9600,N,8,1] Set the the | |
|
| baud, no parity, 8 data bits, and 1 |
|
| stop bit. |
E01CP} | X5@,X5#,X5$,X5%] |
|
E0*X5^TC} | Pti0*X5^] |
|
E0TC} | X5^] |
|
E1*X5^TC} | Pti0*X5^] |
|
E1TC} | X5^] |
|
EX5&CV} | VrbX5&] |
|
ECV} | X5&] |
|
GSS 100 Graphic Still Store • Programming Guide 27
