Extron electronic ISS 506 manual Reset button, Serial port connection

Installation, cont’d

Serial port connection

L	RS-232/422 port — Connect a host device, such as a computer or touch
	panel control, to the ISS 506 Integration Seamless Switcher via this 9-pin D
	connector for serial RS-232 or RS-422 control (figure 2-14).
		Pin	RS-232	Function	RS-422	Function
		1	—	Not used	—	Not used
		2	TX	Transmit data	TX–	Transmit data (–)
	RS232/422	3	RX	Receive data	RX–	Receive data (–)
		4	—	Not used	—	Not used
		5	Gnd	Signal ground	Gnd	Signal ground
		6	—	Not used	—	Not used
		7	—	Not used	RX+	Receive data (+)
		8	—	Not used	TX+	Transmit data (+)
		9	—	Not used	—	Not used

Figure 2-14 — Remote port pin assignments

See chapter 4, “SIS Programming and Control”, for definitions of the SIS commands and chapter 5, “Scaler Software”, to install and use the control software.

Reset button

M	Reset button — The Reset button initiates four levels of reset	LAN
	to the matrix switcher. Use and Extron Tweeker or small
	screwdriver to press and hold the button while the switcher is		RESET
	running or while you power up the switcher, for different reset
	levels.

See “Rear Panel Reset Button” in chapter 3, “Operation”, for details.

•Events (mode 3) reset — Hold Reset for 3 seconds, then release it and push it again to toggle events monitoring on and off.

•IP settings (mode 4) reset — Hold Reset for 6 seconds, then release it and push it again to reset the switcher’s IP functions.

NIP settings reset does not replace any user-installed firmware.

•Absolute (mode 5) reset — Hold Reset for 9 seconds, then release it and push it again to restore the switcher to the default factory conditions (without resetting the firmware).

•Hard reset — Hold Reset while powering up the switcher to revert to the factory default firmware (in the event that firmware incompatibility issues occur).

2-10 ISS 506 Integration Seamless Switcher • Installation