Extron electronic PVS 400, 300, 200 Installation - Stage One, cont’d, Verify the image location

Installation — Stage One, cont’d

e.Using suitable screws, mount the projector onto the lower portion of the UPB 25 (the projector bracket, as shown in step 2e’s image). Align it so the security flange is at the rear. A minimum of three arms need to be attached to the projector Adjust the arms to fit as needed. Lock down the arm adjustment screws.

TAdjust the threaded barrels at the end of each arm to keep the bracket level.

Security

Flange

2e Attach the bracket to the projector

f.Lift the projector up to the mount plate and slide it into place. Tighten down the locking and pivot screws.

2f Slide and lock the projector onto the adjuster plate

3.Verify the image location

a.Connect a power cable to the projector and turn it on.

b.Verify image size and location by loosening the

PCM 240 pipe adapter plate locking nuts, and adjust the plate (left-right) to center the image.

TRemember to include the vertical and horizontal offsets when aligning the projector. Refer to the projector manual for information.

c.When satisfied lock down the plate locking nuts.

Projector

Center Line

Measure the horizontal offset

Lens

Center Line

THorizontal offset

2-4 PoleVault Systems Installation • Installation — Stage 1