Extron electronic 200, PVS 400 Install the PVS 204SA switcher, power cord to the rear of switcher

3.Install the PVS 204SA switcher

a.Pass two 4-40 x 3/16" screws up through the PMK’s bottom plate into the holes in the base of the PVS 204SA switcher, and secure it in place at the left front of the bottom plate.

NDo not install the rubber feet on the switcher when installing the device in the PMK.

b.Install the power supply on the right rear of the

PMK 450 bottom plate and secure it using velcro.

	Front	PMK 450
	(towards screen)
		Bottom Plate
Extron
		Extron
PVS 204SA		Power
™		Supply
PoleVault
Switcher

Secure to PMK

with Velcro pads

Secure to PMK with Screws (2)

3a Install the switcher and 3b power supply onto the base plate of the PMK 450

c.Attach the supplied 2-pole male captive screw connector

to the cord of the supplied power source and connect the	Smooth	Ridges
power cord to the rear of switcher.	A
		A

TInsert the extra captive screw connectors into any ports which are not going to be used at this time. This keeps the connectors handy for any future system

modifications.	Power Supply
	Output Cord

SECTION A–A

2-pole Captive

Screw

Connector

Tie Wrap

3

3c Wire the captive screw connector for the power supply

d.Set the DIP switches on the rear panel of the

PVS 204SA to Dual Mono and high pass filter off.

Refer to the PVS 204SA User’s Manual for details.

	I
	N
POWER	P
	U
	T
	S
12V
3A MAX

RGBVIDEO

1A 2A 3

1B 2B 4

RGB

O

U

T

P

U

T

S

VIDEO

III IIIIII IIIII IIIIII IIIII A024ERD56 E 235411 WO564871-12	PVS 204SA PoleVault Switcher
S/N

		LISTED 17TT				AMPLIFIED OUTPUTS
®	US AUDIO/VIDEO			DO NOT GROUND			4/8
		APPARATUS			OR SHORT		Ohms
Plenum Rated UL 2043				SPEAKER OUTPUTS
Suitable for Use in Air-Handling Spaces						L	R
	ON	STEREO	AUX/MIX IN		RS-232 MLC/IR		DC VOL
HIGH	ON				Tx Rx IR	12V
PASS
FILTER
	OFF	DUAL			A B C		10V
		MONO					VOL/MUTE

Power Supply	Dual DIP
Connector	Switch
	3d Set the DIP switches as desired

e.Install any other optional devices, such as the Extron Priority Page Sensor Kit on the PMK 450, following the installation steps in the devices’ user’s manuals. See the “Optional Accessory Installation — PPC-25” section, page 2-30 for an overview.

PoleVault Systems Installation • Installation — Stage 4 2-23