Operation, cont’d

Input video type

After selecting Demo mode (as previously described), the desired video input type for Input 1 may be selected by pressing the Audio button and rotating the encoder knob to select either auto, video, or S-video. Auto will automatically select the active input or, if both video and S- video are active, S-video is selected. Press the Audio button again to select the input type for Input 2. If no button is pressed within 8 seconds, the SVS 100 exits the Advanced menus.

INPUT #1

AUTO

INPUT #1

VIDEO

INPUT #1

S-VIDEO

INPUT #2

AUTO

INPUT #2

VIDEO

INPUT #2

S-VIDEO

Audio switching method

After selecting an input video type (as previously described), the desired audio switching method may be selected by pressing the Audio button and rotating the encoder knob to select either start, middle, end, or fade.

Selecting start will switch to the next audio input at the beginning of the next video input. Selecting middle will switch to the next audio halfway into the next video input. Selecting end will switch to the next audio at the end of the next video input. Selecting fade will gradually mute the current audio halfway between the switch to the new video input, then gradually increase the new audio input from mute.

AUDIO SW

START

AUDIO SW MIDDLE

AUDIO SW

END

AUDIO SW

FADE

VCR mode

After selecting an audio switching method (as previously described), the VCR mode for an input may be selected by pressing the Audio button. Selecting the VCR mode for an input will eliminate horizontal noise from the input source. Press the input button(s) to toggle the VCR mode On (Y) or Off (N).

VCR MODE Y Y Y N

3-8 SVS 100 Operation

Page 26
Image 26
Extron electronic SVS 100 manual Input video type, Audio switching method, VCR mode