Extron electronic SVS 100 manual Cabling and Rear Panel Views, Rack mounting, Power connection

Rack mounting

Rack mount the switcher as follows:

1. Attach the rack mount brackets to the switcher with eight #8 machine screws, provided (see figure 2-1).

2. Insert the switcher into the rack, align the holes in the mounting bracket with those of the rack.

3. Secure the switcher to the rack using the supplied machine screws.

Cabling and Rear Panel Views

All connectors are on the rear panel (see figures 2-2, 2-3, and 2-6).

Power connection

2 3 2 3 2 2

100-240V

50/60 Hz 0.5A

IN

OUT

INPUT 1

IN

OUT

INPUT 2

ININ

OUTOUT

INPUT 3 INPUT 4

1 4 5 4 5 4 4

Figure 2-2 — Power, video input, and buffered video outputs

1AC power connector — Plug a standard IEC power cord into this connector to connect the switcher to a 100 to 240VAC, 50 Hz or 60 Hz power source.

Video input and output connections

2

3

4

5

Input 1, Input 2, Input 3, and Input 4, composite video inputs — Connect

composite video inputs to these BNC connectors.

Input 1 and Input 2, S-video inputs — Connect S-video inputs to these 4-pin mini-DIN connectors. If both composite video and S-video are connected to Input 1 or Input 2, the switcher can autoselect the active line if the input has been configured as “Auto”. See Advanced Menus and the Input video type section in chapter 3. If both lines are active, S-video is selected.

Input 1, Input 2, Input 3, and Input 4, composite video buffered outputs —

These BNC connectors output unswitched bufferd loops of the composite video input. The buffered output loops are always active, independent of autoselection. See Advanced Menus and the Input video type section in chapter 3.

Input 1 and Input 2, S-video buffered outputs — These 4-pinmini-DIN connectors output unswitched buffered loops of the S-video input. The buffered output loops are always active, independent of autoselection. See Advanced Menus and the Input video type section in chapter 3.

SVS 100 Installation 2-3