Extron electronic TPS150 TP and audio output connections, 5 - Wiring the audio output connector

TP and audio output connections

5Output UTP Link connector — Connect one end of a TP cable to this RJ-45 female connector on the transmitter.

Connect the free end of the same TP cable from the transmitter to the RJ-45 female connector on the receiver.

See TP cable termination, on page 2-8, to properly wire the RJ-45 connector.

The TPS150 works with either shielded or unshielded cables. However, to comply with FCC rules, shielded (STP or FTP) cables must be used.

6Output Audio connector — Connect an audio device, such as powered speakers, to this 3.8 mm, 5-pole captive screw connector for balanced or unbalanced audio output.

Figure 2-5 shows how to wire the captive screw audio connector. The connector is included with the transmitter, but you must obtain the cable. Insert the wires into the appropriate openings in the captive screw connector. Tighten the screws on top to fasten the wires.

Tip	L	Left	Tip	L	Left
NO GROUND HERE.			Ring
Sleeve(s)
Tip	R	Right	Tip	R	Right
NO GROUND HERE.			Ring

0.2” (5 mm) max. Unbalanced Stereo Output Balanced Stereo Output

Do not tin the wires!

Figure 2-5 — Wiring the audio output connector

CAUTION

Connect the sleeve to ground (Gnd). Connecting the sleeve to a negative (-) terminal will damage the audio output circuits.

CAUTION

The length of the exposed (stripped) copper wires is important. The ideal length is 0.2" (5 mm). Longer bare wires can short together. Shorter wires are not as secure in the direct insertion connectors and could be pulled out.

The audio output always follows the video switch.

Remote control connections	CONTACT
	CLOSURE
7 Contact Closure — If desired, connect an optional	GND
CTP150CM control panel module or other contact closure	PROJ PWR
device to this 8-pin 3.5 mm captive screw connector. Refer to	VOL DN
the CTP150CM manual.	VOL UP
To make your own contact closure device, wire the connector	IN4
	IN3
as shown at right. To issue a switching, volume, or projector
	IN2
power command, momentarily short the appropriate pin to
	IN1
ground.

TPS150 Switching and Transmission System • Installation 2-5