Extron electronic TPS150 manual Receiver controls and indicators, 2 - TPR150 receiver front panel

5

6

7

Volume up and down buttons — The Volume up () and Volume down () buttons are used to increase and decrease the output volume and the selected input’s audio level. See “Volume adjustment” on page 3-5 for more details.

The Volume buttons are also used to reset the transmitter. See “Full system reset” on page 3-5.

Mute button and LED — Press the Mute button to toggle audio mute on and off. When the output is muted, the transmitter outputs no audio on its local Audio connector. The Mute LED lights to indicate that the audio is muted.

Faceplate posts — These posts can hold an optional custom-engraved name plate. Extron can create a custom front plate to neatly and professionally label each input button. Contact the Extron S3 Sales & Technical Support Hotline to order the custom plate.

Receiver controls and indicators

The receiver has controls on the front panel and the rear panel (figure 3-2).

CABLE EQUALIZATION

- ADJUST +	SELECT
	LOW FREQ.
	HIGH FREQ.

POWER

TPR150 Twisted Pair Video Receiver

11 10 9 8

		VIDEO OUTPUT
		COMPOSITE	COMPONENT
UTP LINK	RGB / VGA	S-VIDEO
SKEW	ADJ
RED BLUE GRN		R-Y	Y	B-Y

90-260VAC; 0.25A; 47-63Hz

RS-232 PORT

FUSE: 1.6A; 250V; TIME DELAY

Figure 3-2 — TPR150 receiver front panel

8Power LED — When lit, the Power LED indicates that power is applied to the receiver.

9Cable Equalization Select button and LEDs — Press the Select button to toggle between high frequency and low frequency to equalize. The High Frequency LED and Low Frequency LED indicate the frequency range that is selected for equalization. Equalize the cable with the Adjust button ( 10 ). See “Optimizing the Video” on page 3-6 for more details.

10Cable Equalization Adjust button — Press the + side of the button to increase the amount of equalization applied to the selected frequency range (high or low) of the output signal. Press the – side of the button to decrease the amount of equalization. Select the frequency range with the Select button ( 9 ). See “Optimizing the Video” on page 3-6 for more details.

11Skew Adjustment controls — Use an Extron Tweeker or other small screwdriver to correct for the delay inherent in network (CAT 5) cable. See “Optimizing the Video” on page 3-6 for more details.

TPS150 Switching and Transmission System • Operation 3-3