Extron electronic Quick Start - TPS150 Switching and Transmission System, Installation, Step

Quick Start — TPS150 Switching

and Transmission System

Installation

Step 1

Turn off power to the input and output devices, and remove the power cords from them.

Step 7

Connect a host device to the transmitter via this 9-pin D connector and a null modem serial port cable for serial RS-232 control.

Step 2

If desired, mount the TPT150 transmitter in a rack.

Step 3

If desired, mount the TPR150 receiver using the included projector bracket.

Step 4

Connect source video devices to the transmitter’s

		TPS150
5	1	pin
		1
		2
9	6	3
		4
Female
		5
		6

7

8

9

Connected

RS-232

device pin

—

RX

TX

—

Gnd

—

—

—

—

Function

Not used Receive data Transmit data Not used Signal ground Not used Not used Not used Not used

inputs.

Inputs 1 and 2 — Connect two RGB video sources.

If desired, connect a

monitor to the Input 1 Local Monitor connector.

Inputs 3 and 4 —	VIDEO	R-Y
Connect either
component video,	S-VIDEO
S-video, or
composite video
sources.

Step 8

Connect an optional CTP150CM control panel module or other contact closure device to this 8-pin

3.5mm captive screw connector. See chapter 2, “Installation”.

To make your own contact closure device, wire the connector as shown at right. To issue a command, momentarily short the appropriate pin to ground.

CONTACT

CLOSURE

GND

PROJ PWR

VOL DN

VOL UP

IN4

IN3

IN2

IN1

For proper	Y	B-Y
system operation, connect only one video
format to input 3 and input 4.

Step 5

Connect audio devices to the input 1	L
through input 4 left and right RCA
connectors.	R

Step 6

Step 9

Connect a Category (CAT) 5/5E6, unshielded twisted pair (UTP), shielded twisted pair (STP), or foil shielded pair (FTP) cable with RJ-45 connectors between the transmitter and receiver. Terminate both cable ends per either

TIA/EIA 568 A or 568 B.

To comply with FCC emission limits, use shielded (STP or FTP) cable only.

Connect an audio device, such as powered speakers, to this 3.8 mm, 5-pole captive screw connector for balanced or unbalanced audio output.

Side Clip Down

RJ-45 connector

	568 A	568 B
Pin	Wire color	Wire color
1	White-green	White-orange

Tip

NO GROUND HERE.

Sleeve(s)

Tip

NO GROUND HERE.

Unbalanced Output

Tip

Ring

Sleeve (s)

Tip

Ring

Balanced Output

CAUTION Connect the sleeve to ground. Connecting the sleeve to a negative (-) terminal will damage the audio output circuits.

12345678

2	Green	Orange
3	White-orange	White-green
4	Blue	Blue
5	White-blue	White-blue
6	Orange	Green
7	White-brown	White-brown
8	Brown	Brown

1&2	7&8 Twisted
3&6 4&5	Pairs

TPS150 Switching and Transmission System • Quick Start QS-1