Extron electronic TPS150 manual 5 - Connected window

9. Click Inline Model > Query Hardware to configure the ICS100 program to communicate with the TPT150 and to confirm that communications have been established with the transmitter. The connected window appears (figure 4-5).

Figure 4-5 — Connected window

10. Click OK.

11. Use the software to configure serial port settings, program the input and projector codes, and/or operate the transmission system. See the procedures on the following pages.

After you are finished sending commands to the transmitter, always end the session by selecting a different address from the one assigned to the TPT150. This prevents the transmitter from responding to commands meant for another unit.

12. Click Inline Model > Select Address. The Addresses window (figure 4-4) appears.

13. Click and drag on the slider or click the scroll up () or scroll down () button until an address other than the transmitter’s address is visible.

14. Click on the desired address.

15. Click OK.

TPS150 Switching and Transmission System • Serial Communications 4-5