Extron electronic TPS150 manual Receiver connections, Power connection, UTP Link Input connection

Installation, cont’d

8RS-232 port — Connect a host device, such as a computer or touch panel control, to the TPT150 transmitter via this 9-pin D connector and a null modem serial port cable for serial RS-232 control (figure 2-6).

TPS150	Connected
	RS-232	Function
pin	device pin		5	1
1	—	Not used
2	RX	Receive data
3	TX	Transmit data	9	6
4	—	Not used
			Female
5	Gnd	Signal ground
6	—	Not used
7	—	Not used
8	—	Not used
9	—	Not used

Figure 2-6 — Remote port pin assignments for the TPT150 and TPR150

See chapter 4, “Serial Communications”, for definitions of the ASCII commands and instructions to install and use the control software.

Power connection

9AC power switch — Toggle the AC power switch to the on ( ) position to turn on the transmitter.

10AC power connector — Plug a standard IEC power cord into this connector to connect the transmitter to a 100 to 240VAC, 50 Hz to 60 Hz power source.

Receiver connections

All receiver connectors are on the rear panel (figure 2-7).

VIDEO OUTPUT

COMPOSITE

UTP LINK RGB / VGA S-VIDEO

SKEW ADJ

COMPONENT

90-260VAC; 0.25A; 47-63Hz

RS-232 PORT

	RED BLUE GRN		R-Y	Y	B-Y
						FUSE: 1.6A; 250V; TIME DELAY
11	12	13	14	15	16	17

Figure 2-7 — TPR150 receiver rear panel connectors

UTP Link Input connection

11Input UTP Link connector — Connect the free end of the TP cable from the transmitter to this RJ-45 female connector on the receiver.

See “TP Cable Termination”, on page 2-8, to properly wire the RJ-45 connector.

The TPS150 works with either shielded or unshielded cables. However, to comply with FCC rules, shielded (STP or FTP) cables must be used.

2-6 TPS150 Switching and Transmission System • Installation