Extron electronic TPS150 Using the help system, button mutes and unmutes the audio output, unity

Serial Communications, cont’d

2.	With the exception of input audio level, the controls on the control panel
	window operate the same as the physical front panel of the transmitter. See
	chapter 3, Operation.
		If you click the Projector On or Projector Off button, the Projector Power
		LED on the transmitter’s front panel blinks while the delay times out. All
		front panel operations are disabled during the delay.
		The	button mutes and unmutes the audio output.
3.	For input volume control, click Controls > Input Volume. The Set Input Volume
	window appears (figure 4-15).

Figure 4-15 — Set Input Volume window

	a.	For each input, select that input on the front panel.
	b.	Click and drag on the slider or click the scroll up ( ) or scroll down ( )
		button to adjust the input level from 0dB (unity) through –15dB as
		required for best performance.
		Clicking the Reset Volume button resets each input’s audio level to 0db
		(unity).
4.	Click in the upper right corner of the window to close the window.
5.	If no further operations are to be performed, halt communication with the
	switcher by selecting a different address. See “Establishing communications
	with the program”, step 12.

Using the help system

For information about program features, you can access the help program in the following ways:

•From the ICS100 startup window, select Help from the Help menu.

•From the Button Codes window, press the F1 key.

4-10 TPS150 Switching and Transmission System • Serial Communications