Falcon F1000, F3400 manual Rear Panel Indicators, SW1 Switch Settings

1System Overview

1.4.Rear Panel Indicators

The rear panel of the F3400/F1000 houses a pair of green LEDs. The chart below tracks indicator status when the corresponding green LED is illuminated:

Table 1.2 Rear Panel Status Indicators

EIA232 or EIA485	TX (COM1) Interface	Data is being transmitted.
EIA232 or EIA485	RX (COM1) Interface	Data is being received.

Figure 1.3 Rear LED Indicator and Status

1.5.SW1 Switch Settings

SW1-1:EIA485 Termination switch should be On (down) if the F3400/F1000 is the end device on an EIA485 network. The switch should in the OFF (up) position if the device is at the beginning or in the middle of an EIA485 network.

SW1-2:EIA485 Termination switch should be On (down) if the device is connected via a four wire connection. OFF (up) if the device is connected via a two wire connection.

Figure 1.4 SW1 Switch Is On and SW2 Switch Is Off

www.rletech.com 18 970.484.6510