8 Upgrading Firmware and Managing Configuration Data
8.2.3 Loading Configuration Data via TFTP Client
Before the configuration can be loaded onto other F3400/F1000s, it must be checked for accuracy. Blank spaces or unwanted characters, such as the “Press <enter> to download the file” text, may be saved into the beginning of the configuration file. Open the file in Notepad and examine the first few lines. Delete any characters that were accidentally embedded into the file.
1Verify that your PC is connected to the F3400/F1000 over the LAN and that port 69 is open between your PC and the Falcon.
2Open your TFTP client. Configure the client as follows. a Host = F3400/F1000 IP Address
b Port = 69
c Block Size = 64, 128, 256, 512, or 1024
Note The file must be sent in BINARY (not ASCII).
3The file name of the configuration being loaded must contain the .cfg extension.
4Send or PUT the file. After a few seconds, the TFTP software should indicate when it is complete.
5Configurations are now loaded onto the replacement F3400/F1000. View the Falcon webpages to verify that the configurations are as expected.
8.2.4Loading Configuration Data via EIA232 COM1 Port (X-Modem)
Before the configuration can be loaded onto other F3400/F1000s, it must be checked for accuracy. Blank spaces or unwanted characters, such as the “Press <enter> to download the file” text, may be saved into the beginning of the configuration file. Open the file in notepad and examine the first few lines. Delete any characters that were accidentally embedded into the file.
1To load settings, go to the F3400/F1000 onto which the configuration will be loaded. Log into the F3400/F1000 (COM1) through HyperTerminal (Terminal Emulation Program). Navigate to the Load/Save Configuration Data Menu under the Main Configuration Menu.
2Select option 2 (Load ENTER. Then select screen.
Xmodem 1K) from the Load/Save Configuration Menu and press Transfer/Send File from the menu at the top of the HyperTerminal
3Select the 1K
4Wait until the Upload is completed and enter X to exit the Load/Save Configuration Menu.
www.rletech.com | 77 | 970.484.6510 |
