5
5.3.Main Menu
All system functions begin in the Main Menu. Two letter commands display information, execute commands and display submenus for additional inquiry and system configuration functions.
Table 5.1 Main Menu Commands | |||
|
|
|
|
Command | Description | Function | |
|
|
|
|
CA | Current Alarms | CA displays all active alarms on the master unit. If alarms | |
|
| are present, the System Status LED is red. | |
|
|
|
|
KA | Kill Alarms | KA acknowledges all alarms and terminates all | |
|
| communications and network Traps. | |
|
|
|
|
TI | Display Date/ | TI displays the F3400/F1000's current time and date. | |
| Time |
|
|
|
|
|
|
AD | ADC Input | AD allows the user to examine the readings of the | |
| Values | inputs. These readings can be referenced during | |
|
| verify gain and offset calculations. Data displayed depends | |
|
| on the expansion card(s) installed. | |
|
|
|
|
MS | Modem | MS provides a summary of all modem information. | |
| Statistics |
|
|
|
|
|
|
NS | Network | NS displays network and EIA485 statistics including: | |
| Statistics | network packets received, packets transmitted, and errors. | |
|
|
|
|
SC | Main | SC displays a submenu that lists all items for system setup | |
| Configuration | and configuration. | |
|
|
|
|
DU | Dump Network | DU dumps the headers of all network packets received and | |
| Packets | sent. Only active until the next command is entered. This | |
|
| item is for network debugging only and is not normally | |
|
| enabled. | |
|
|
|
|
NT | Network Trace | NT displays troubleshooting messages during the | |
|
| processing of network packets. Only active until the next | |
|
| command is entered. Network Trace is for network | |
|
| troubleshooting only and is not normally enabled. | |
|
|
|
|
PING | PING | Allows user to PING another device on the network. | |
|
|
|
|
EX | Exit to | EX is used to enter the Bootloader command section. The | |
| Bootloader | unit will stop monitoring the inputs and allow firmware | |
|
| updates to be loaded. To restore normal operation after | |
|
| updating firmware, type run and press Enter on the | |
|
| keyboard, or power the unit off and back on again. | |
|
|
|
|
|
|
|
|
| The Bootloader section is designed for experienced technicians or users |
| responsible for maintaining the system. Exit immediately if you have not been |
WARNING | trained in the use of the Bootloader commands. Contact RLE for more |
information regarding the commands in this section. | |
|
|
www.rletech.com | 65 | 970.484.6510 |
