Finalizing the Installation (for qualified installers only) 47
© Travis Industries 4080214 100-01182_003
Fireback and Grate Installation

WARNING: Firebacks are required for this fireplace and must be installed prior to operation.

1 Remove the glass frame.

3 Remove the exhaust restrictor (see page 23). Make sure to return the restrictor to the correct position after

the firebacks are in place.

4 Install the firebacks and grate following the directions below.

Place the rear fireback in place. The side
fireback holds the rear fireback in place -
hold the rear fireback while installing the
side fireback.
Remove the screws and
clips on both sides. b
Place the side firebacks
in place. Secure using
the screws and clips
removed in step “a”.
Place the floor
firebacks in place.
c
d
5/16" Nutdriver
a
Place the grate in place. Take care to
prevent it from damaging the ceramic
firebacks.