■
■
■
■
Installation instructions | 7 |
|
Before connection
Important!
Ensure that your appliance has not suffered any damage during transport (bent door or seal, etc.). If you notice any kind of damage, contact your retailer before using the appliance.
In order to easily locate the make, model number, etc. of your appliance, we recommend that you note this information on the ‘Warranty and service’ page.
If the power cable is damaged, it should be replaced by the manufacturer, its
Installation should only be performed by installers and qualified technicians.
■
■
■
Electrical specifications
Electrical connection rating: 3.4 kW
Voltage/frequency:
Current: 16 A
Please verify electrical specifications by checking the appliance rating label.
Electrical connection
Ensure that:
■The electrical installation has sufficient voltage.
■The electrical wires are in good condition.
■The diameter of the wires complies with the installation requirements.
■Your electrical installation is equipped with
■The oven is connected to a single phase
■A suitable isolating switch providing full disconnection from the mains power supply is incorporated in the permanent wiring, mounted and positioned to comply with the local wiring rules and regulations. The isolating switch must be of an approved type and provide a 3 mm air gap contact separation in all poles (or in all active [phase] conductors if the local wiring rules allow for this variation of the requirements)
■The isolating switch will be easily accessible to the customer with the oven installed.
■If in doubt, consult your electrician.
Electrical connections should be completed before the appliance is placed in the wall unit.
The appliance must be
If the power cable is damaged, it should be replaced by the manufacturer, its
Important:
We cannot accept liability for any accident or incident resulting from
If the oven malfunctions in any way, disconnect it from the power supply or remove the fuse for the oven’s connection line.