Frymaster 45, 35 manual Place the gas valve in the OFF position

35-Series Non-CE Standard

Burner Manifold Gas Pressures

Gas	Pressure
Natural	4.0” W.C.
	0.87 kPa
Propane	9.0” W.C.
	2.24 kPa

35-Series CE Standard

Burner Manifold Gas Pressures

Gas	Pressure
Natural Gas Lacq	9 mbar
(G20) under 20 mbar
Natural Gas Gronigue*	11 mbar
(G25) under 25 mbar
Natural Gas Gronigue*	11 mbar
(G20) under 20 mbar
Propane	22.5 mbar
(G31) under 37 or 50 mbar

* Belgian G25 and G20 = 9.0 mbar

45-Series Non-CE Standard

Burner Manifold Gas Pressures

Gas	Pressure
Natural	3.5” W.C.
	0.73 kPa
Propane	8.25” W.C.
	2.05 kPa

45-Series CE Standard

Burner Manifold Gas Pressures

Gas	Pressure
Natural Gas Lacq	7.5 mbar
(G20) under 20 mbar
Natural Gas Gronigue*	10 mbar
(G25) under 25 mbar
Natural Gas Gronigue	10 mbar
(G20) under 20 mbar
Propane	20.6 mbar
(G31) under 37 or 50 mbar
* Belgian G25 = 7.0 mbar

8.Use a flat-head screwdriver to adjust the gas valve regulator adjustment screw to obtain the prescribed pressure written on the rating plate or one of the charts above. (Use the diagram on below to locate this screw.) Turn the screw clockwise to increase gas pressure and counterclockwise to decrease gas pressure.

9.On non-CE units, reinstall the gas valve regulator cap screw when the correct manifold pressure is obtained.

10.Place the gas valve in the OFF position. Remove the fitting from the pressure tap hole and reinstall the pressure tap plug.

11.Place the gas valve in the PILOT position. Re-light and check for any gas leaks.

12.Place the gas valve in the OFF position.

To access the pilot adjustment screw on non-CE valves, this cap must be removed.

Pilot Adjustment Screw

Gas Valve Regulator Adjustment Screw

Honeywell Valve	Honeywell Valve
(Non-CE Units)	(CE Units)

Locating the gas valve regulator adjustment screw and pilot adjustment screw.

1-4