111

Macintosh

110

Macintosh
Possible cause Solution

■Live images do not appear in the VideoImpression Capture window.

Is the cradle switched on?
Is the camera’s lens cover open?
Is the special USB cable connected to
the cradle and to the computer?
Are you using a compatible operating
system?
Is PC Camera Driver enabled?
Is another video input device selected?
Is another application displaying the
live images from the camera?
Did you disconnect the special USB
cable or switch off the camera during
live image display?
1Connect the AC power adapter to the
cradle and place the camera in the
cradle.
2Open the lens cover.
3Slide the power switch on the camera to
the right to switch the camera on.
1Switch the camera off using the correct
procedure.
2Open the lens cover.
3Slide the power switch on the camera to
the right to switch the camera on.
Check that one end of the special USB
cable is connected to the cradle and the
other end is connected to the computer.
The USB Driver should be used with Mac
OS 8.6 to 9.1. (It is not compatible with
Mac OS X.)
Enable “USB04CB_VcShim” and
“USB04CB_VcDriver” in the Extensions
Manager and restart your Macintosh.
Select “USB PC Camera”. Refer to the
VideoImpression User’s Guide for information
on how to select the video input device.
Quit any other application that is
displaying live images.
Quit VideoImpression and then restart your
Macintosh. Check that the special USB
cable is connected correctly to the cradle
and your Macintosh and then switch the
camera on.
Troubleshooting Other Problems
Possible cause Solution

■My camera will no longer play back image files.

Did you rename any files or folders
inside the “DCIM” folder?
Did you replace an image file inside the
“DCIM” folder?
Change the file or folder names in the
“DCIM” folder back to the original names.
Do not replace image files in the “DCIM”
folder.
Solution

■I want to stop the FinePixViewer from launching automatically.

You can use either of the two methods below to prevent FinePixViewer from launching
automatically.
• Change the Exif Launcher settings.
1Select “Exif Launcher Settings” in the FinePixViewer “Settings” menu and click “Do
not run Exif Launcher at restart.”
2Restart your computer.
✽To restore the original setting, use the same procedure and tick the “Run Exif
Launcher at restart.” option.
• Remove Exif Launcher.
1Select “Exif Launcher Settings” in the FinePixViewer “Settings” menu and tick “Quit
Exif Launcher immediately”.
2Move “Exif Launcher” from the “Startup Items” folder in the System folder to the
Trash.
3Select “Empty Trash” in the “Special” menu.
✽To restore Exif Launcher, re-install the software.