Chapter 4 Secondary LAN port on

PRIMEPOWER250/450

This chapter describes how to use the secondary LAN (10/100/1000Mbps) port on PRIMEPOWER250/450.

4.1Outline

The secondary LAN port on PRIMEPOWER250/450 is controlled by FUJITSU PCI Gigabit Ethernet Driver (Interface name is “fjgi”) included in Solaris 10.

4.2Notes

zWhen using 1000 Mbps communication, be sure to set Autonegation to 'on'.

zIf using the PCI card (PW008GE4/PW008GE5/PW008QG1), please refer to the User’s guide attached with the PCI card.

4.3How to Set Configuration Information

This section describes required setting to use a fjgi interface.

4.3.1Environment Setting

This section describes how to edit files required to build environment.

4.3.1.1Determining the Client Name of Target Driver

1.To use the secondary LAN port as an IPv4 interface:

To allocate the IP address or hostname to the fjgi interface, edit /etc/hostname.fjgi* (* is an numerical value) file. About netmask value, please see "4.3.1.3 Defining Netmask Value" .

Example /etc/hostname.fjgi*:

Define the unique hostname:

giga-v4

or, define the IP address:

192.168.150.1

Note: If you defined the hostname in hostname.fjgi* file, see the section "4.3.1.2 Defining Hostname " for detailed information.

2.To use the secondary LAN port as an IPv6 interface

To allocate the IP address and prefix to the fjgi interface, edit /etc/hostname6.fjgi* (* is an numerical value) file.

15