Support
Support
Not Supported
(Supported V4.1A10 or later)
Not Supported
(Supported V4.1A10 or later)

z1:n operation standby mode

zMutual standby mode

zTCP/IP communication

zUsing to the cluster interconnect (PRIMECLUSTER). (But, using in a JumboFrame or as VLAN interface can not be performed)

The support ranges of takeover form are the following ranges.

a.PRIMECLUSTER

Taking over form

IP

MAC

IP+ MAC

Caution

Using over operation management LAN (LAN used for cluster operation management view) cannot be supported.

4.5.2Cluster Environment Setup Procedure

Set up the cluster environment in the same way as for the other LAN driver, follow "Setting up the Network" in the "PRIMECLUSTER manual". Note that the secondary LAN port (fjgi interface) resource name is "fjgi".

4.5.3Notes in Cluster Environment

Please use "PRIMECLUSTER 4.1 or later" for a cluster system to use fjgi interface. If an earlier version of cluster system is used, fjgi interface cannot be used for private LAN nor for IP address fail-over on public LAN.

When using fjgi interface as the cluster interconnect, please perform the following command before initial composition setup.

#ifconfig fjgi* plumb <Return>

* is instance-number

Then, please execute the following command and check that a MTU size of fjgi interface is not 9000byte (JumboFrame is not set up).

#ifconfig fjgi* <Return>

*is instance-number

GigabitEthernet in a JumboFrame function cannot be used to the cluster interconnect.

GigabitEthernet as VLAN interface cannot be used to the cluster interconnect.

29