Fujitsu B23Q8YA-G-02-F Value, Parameter, Description, Table 4.1 Parameters List

Table 4.1 Parameters List

Parameter	Value		Description
name	fjgi	When using PRIMEPOWER250/450
		secondary LAN port, please set
		name="fjgi".
	FJSV,pgtb	When using PCI card PW008GE5,
		please set name="FJSV,pgtb".
	FJSV,pgsb	When using PCI card PW008GE4,
		please set name="FJSV,pgsb".
parent	Please refer to “4.3.2.1.2 How to Set	The location of the device node in a
	Parameter”.	device tree is specified.
unit-address	Please refer to “4.3.2.1.2 How to Set	The address within a device node is
	Parameter”.	specified.
AutoNegotiation_A	On (Default)	AutoNegotiation is enabled. (In this
		setting, unable to connect to the
		remote device of a fixed mode.)
		When you use 1000Mbps, please use
		in Autonegotiation_A="On" (default)
		mode.
	Off	AutoNegotiation		is	disabled.	(Fixed
		mode)
LinkSpeed_A	Auto (Default)	Connect in 1000/100/10Mbps by the
		connection partner.(This can be set
		when AutoNegotiation_A="On".)
	1000	Connect in 1000Mbps.
	100	Connect in 100Mbps.
	10	Connect in 10Mbps.
DuplexCapabilities_A	Both (Default)	Indicating that both Full-Duplex and
		Half-Duplex are being supported.
		(This	can	be	set	when
		AutoNegotiation_A="On".)
	Half	Half-Duplex operation is allowed.
	Full	Full-Duplex operation is allowed.
FlowControl_A	Auto (Default)	A flow control is performed according
		to a setup of partner equipment.
	Rem	Only the flow control from the remote
		machine is allowed. The flow control
		to the remote machine is not allowed.
	LocSend	Only the flow control from the main
		unit is allowed. The flow control from
		the remote machine is not allowed.
	None	Flow control is disabled.

17