Fujitsu C122-H007-01EN A.2.2 Requirements for mounting in a third party's rack

Appendix A Racks

A.2 Rack Mounting Requirements

A.2.2 Requirements for mounting in a third party's rack

When mounting the PRIMEQUEST products in a rack manufactured by another company, customers need to confirm on their own responsibility that the rack meets the PRIMEQUEST product specifications and requirements.

Note

Fujitsu does not guarantee there will be no problems arising from the mounting of the PRIMEQUEST 2000 series server (including peripheral devices) in a rack manufactured by another company.

Examples: Cooling problem due to an insufficient supply of cooling air because of the rack structure, and insufficient earthquake-resistance because the rack manufactured by another company is not strong enough If mounting in a rack manufactured by another company cannot be avoided, confirm that the rack satisfies all of the following structural requirements.

TABLE A.3 Structural condition of rack

Number of Check	Term	Condition	Reference
Length of rack
Check1	Allowable spacing between	685 to 790mm	FIGURE A.2
	posts	(26.7 to 31.1 in.)	Length of rack
Check2	Length between front post and	860mm(33.9 in.) or more	FIGURE A.2
	front cover		Length of rack
Check3	Length between front post and	60mm(2.4 in.) or more	FIGURE A.2
	front cover		Length of rack
Width of rack
Check4	distance between the left and	450mm(17.7 in.) or more	FIGURE A.3 Width
	right posts (common to the		of rack
	front and rear posts)		FIGURE A.4 Format
			of rack posts
Check5	Distance between holes on the	465mm(18.3 in) or more	FIGURE A.3 Width
	left and right device mounting	(EIA standard)	of rack
	posts (common to the front		FIGURE A.4 Format
	and rear posts):		of rack posts
Check6	Bracket installation space	There must not be interference thing	FIGURE A.3 Width
		(post for reinforcement or option) in	of rack
		the shaded portion of figure.
Format of rack
Check7	Pitch of hole	EIA standard, universal pitch	FIGURE A.4 Format
			of rack posts
Check8	Format and size of hole	Length of each side of a square hole:	FIGURE A.4 Format
		9x9(0.35 in.) to 10x10 mm (0.39 in.)	of rack posts
Check9	Cable takeout port	The cable can be taken out of the	FIGURE A.2
		bottom or rear .	Length of rack
Check10	Loading Carrying Capacity of	Total weight must be less than	-
	rack	loading Carrying Capacity of rack.
		Note
		Loading Carrying Capacity of rack
		may change when anti-earthquake
		measures are given.
Check11	Open area ratio of rack	Open area ratio of rack of front cover	-
		and rear cover must be more than
		60%.
Check12	Measure to prevent the rack	Measure to prevent the rack from	-
	from toppling	toppling must be performed.

37 C122-H007-01EN